DNF Controls 2034CL-SX-PBIO - Manual (Page 17)

17 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
Reference . . .
17. FUNCTION TABLE
Function Key Press Description
GANG [SHIFT] + [VTR #1]
OR
[SHIFT] + [VTR #2]
OR
[SHIFT] + [VTR #3]
Individually press the VTR keys to be included in
the gang. The LED above the key will turn on.
Press the VTR key again to remove from gang, the
LED above the key will turn off. Press [ESC] to
exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently
selected.
GOTO
ENTERED TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time
OR use the ST300 numeric keypad, then
Press [ENTER] or [RECUE].
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by
RECORD MODE in the SETUP MENU. Press
[RECORD] or [RECORD] + [PLAY].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the
Wheel (or move the T-Bar, if available) to change
the play speed. Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO]
to preset the slo-mo speed. Turn the Wheel to
select desired speed. Press [ESC] or any transport
key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT [TIME MODE] Press to toggle between Timecode (TC), VITC
(VT) or Tape Timer (TM) display modes.