DNF Controls 2034CL-SX-PBIO - Manual (Page 11)

11 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
9. LEARN
NOTE: The ST300, SHOTBOX and Production Switcher all reference the SAME Cue
List, stored in the ST300. You DO NOT have to LEARN information on the SHOTBOX IF
you have already done so on the ST300 or Production Switcher.
LEARN ON THE ST300
1. Select
the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2. Press [SHIFT] + [MARK] to initiate the LEARN.
The display will show:
3. Press the VTR key desired: [1],[2],[3].
4. Press [MARK] and the ST300 will: LEARN (save) the VTR Number (1,2,3),
loaded CLIP ID and current IN/OUT time to the selected Cue Point.
LEARN ON THE SHOTBOX
1. Press
[LEARN]. The LEARN indicator will turn on.
2. Select the desired BANK and ShotKey.
3. Press [LEARN] to exit at anytime.
NOTE: The [LEARN] key toggles LEARN mode on/off.
LEARN ON THE P RODUCTION S WITCHER
1. Select and enable the Peripheral Device Addresses for the ST300.
2. Do a LEARN to the desired REGISTER.
The ST300 will save the VTR number, loaded CLIP ID and current IN time
into the REGISTER number in the ST300.
10. RECALL
RECALL ON THE ST300
1. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE]
or by manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2. Press [LOAD] on the ST300.
Press VTR:
MARK-Lrn ESC-Cancel