DNF Controls 2034CL-SX-PBIO - Manual (Page 7)

7 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
5. OPERATION MODE SETUP
1. Press [MENU].
2. Press the VTR [1], [2] or [3] to select the VTR you control the DNW from.
3. Turn the Wheel until “Player: REC:” is displayed.
4. Press [MENU] to toggle between the following operation modes of the SX unit:
Player = Ext, REC = Tape Player = Disk, REC = Tape
Player = Ext, REC = Disk Player = Disk, REC = Tape
Player = Tape, REC = Disk
5. Repeat steps 2-4 to configure all SX units you want to configure.
6. Press [ESC] at anytime to exit.
SWITCHING BETWEEN HD and TAPE
Switching between tape and HD, press [TAPE] to assign control to the Tape or the HD.
If the LED above [TAPE] is on you are controlling the tape drive. The time code on the
ST300’s display is the tape drives’ time code and the video signal comes from Tape
(Assuming SX operation mode is set to Player = Tape, Rec = Disk or
Player = Disk, Rec = Tape).
If the LED above [TAPE] is off, you are controlling HD; Time Code and Video come from
the HD. NOTE: The Clip List function is not available on the Tape drive.
When you LEARN on the HD, the CLIP ID, time and data are stored in the Cue Point.
When you do a LEARN and the Tape is active, only current Timecode and Gang data are
stored in the Cue Point.