DNF Controls 2034CL-SX-PBIO - Manual (Page 12)

12 2034CL-SX-PBIO, 300 Clip Instant Access System, Sony SX Protocol
RECALL ON THE SHOTBOX
Select the desired Cue Point by pressing the bank and the switch key.
RECALL ON THE P RODUCTION S WITCHER
1.
RECALL the desired REGISTER NUMBER.
2. The ST300 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned time, then set the Learned GANG mode.
11. TRIGGER
The operator fires a trigger using the Timeline or Run function on the production switcher.
The ST300 puts the Video Server into the following modes based on the trigger value:
GRASS VALLEY GROUP
Trigger Value Mode
0 Play
1 Recue to beginning of clip
2 Slo-mo using ST300 Preset Speed
3 Reverse Play
4 Still Frame
5 LoopPlay
6 or greater Play
SONY
Trigger Value Mode
0 Recue to beginning of clipPlay
1 Play
2 Slo-mo using ST300 Preset Speed
3 Reverse Play
4 Still Frame
5 LoopPlay
6 or greater Play
To control more than one VTR, enable the Peripheral Device Address for the required VTRs.
The Trigger will be sent to the enabled devices.
OR
GANG the required VTRs on the ST300. See the Menu Table for GANG instructions. Enable
the Peripheral Device Address for one of the GANGed VTRs. The Trigger will be sent to the
enabled VTR. The other VTRs in the GANG will perform the same action.