DNF Controls 2034CL-TO-PBIO - Manual (Page 6)

6 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
3. SYSTEM INSTALLATION
a. SHOTBOX
1)
Plug one end of a standard 9-pin, RS422 serial cable, into the OUTPUT
connector on the rear of the SHOTBOX. Plug the other end of the cable into the
AUX connector on the rear of the ST300.
2)
Connect the 5 VDC, 1Amp POWER SUPPLY into the POWER connector on
the rear of the SHOTBOX. Plug the Power Supply into an outlet, 90 VAC –
240 VAC.
b. ST300-S/SM, VTR/DDR CONTROLLER
1)
Plug one end of a 9-conductor, RS422 serial cable into the VTR 1 (2 or 3)
connector on the rear of the ST300. Plug the other end of the cable into the
REMOTE connector on the Video Server.
2)
Connect the +5, +12, -12 VDC POWER SUPPLY into the POWER connector
on the rear of the ST300. Plug the Power Supply into an outlet, 90 VAC - 240
VAC.
3)
Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.