DNF Controls 2034CL-TO-PBIO - Manual (Page 13)

13 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
12. LEARN ON THE ST300
a.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b.
Press [SHIFT] + [MARK] to initiate the LEARN.
The display will show:
c.
Press the VTR key desired, [1], [2], [3], [4].
d. Press
[MARK] and the ST300 will: LEARN (save) the VTR Number (1,2,3), loaded
CLIP ID and current IN/OUT time to the selected Cue Point.
13. LEARN ON THE PRODUCTION SWITCHER
a.
Select and enable the Peripheral Device Addresses for the ST300.
b.
Do a LEARN to the desired REGISTER.
The ST300 will save the VTR#, loaded CLIP ID and current IN time
into the REGISTER number in the ST300.
14. RECALL ON THE SHOTBOX
Select the desired Cue Point by pressing the bank and the switch key.
15. RECALL ON THE ST300
a. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.
16. RECALL ON THE PRODUCTION SWITCHER
RECALL the desired REGISTER NUMBER.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips to the
Learned time, then set the Learned GANG mode.
Press VTR:
MARK-Lrn ESC-Cancel