DNF Controls 2034CL-TO-PBIO - Manual (Page 22)

22 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
27. FUNCTION TABLE
Function Key Press Description
GOTO
ENTERED TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time.
Use the ST300 numeric keypad. Press [ENTER] or [RECUE].
GANG [SHIFT] + [VTR#1]
OR
[SHIFT] + [VTR#2]
OR
[SHIFT] + [VTR#3]
Individually press the VTR keys to be included in the gang. The LED
above the key will turn on. Press the VTR key again to remove from
gang, the LED above the key will turn off. Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
FFWD
[FFWD] Press and HOLD to shuttle. Release key to stop. Set WIND Speed in
MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by RECORD MODE in the
SETUP MENU. Press [RECORD] or [RECORD] + [PLAY].
REWIND
[RWD] Press and HOLD to shuttle. Release key to stop. Set WIND Speed in
MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO
[SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel
(or move the T-Bar, if available) to change the play speed.
Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to preset the slo-mo
speed. Turn the Wheel to select desired speed. Press [ESC] or any
transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
LOOP [SHIFT] + [PLAY] Plays the currently loaded clip in a continuous loop.
TIME MODE
SELECT [TIME MODE] Press to toggle between Timecode (TC), VITC (VT) or Tape Timer
(TM) display modes.