DNF Controls 2034CL-TO-PBIO - Manual (Page 11)

11 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
7. PLAY SINGLE CLIP IN LOOP OR PLAY-TO-LOOP
MODES
a.
LOAD the clip. (The clip MUST be loaded from the DNF Controller.)
b.
Set the IN and OUT points. Press [SHIFT] + [IN]/[OUT] and use the numeric keypad
to enter the desired time, then press [ENTER].
c. Press
[PTL] or [LOOP ENABLE].
d. Hold
[SHIFT] and press [RECUE].
e.
Enter the starting point of the LOOP or PTL, press [ENTER].
f. Press
[PLAY].
g.
To clear the IN or OUT points, hold [DEL] and press [IN] or [OUT].
8. LEARN PLAY-TO-LOOP INTO CUE POINT
Follow steps a and b above to LOAD a clip and set the IN and OUT points; press [PTL].
a. ON THE ST300
1)
Select a Cue Point; press [LAST CUE], [NEXT CUE] or use the numeric
keypad.
2) Press
[SHIFT] + [MARK].
3)
Press the VTR number you wish to learn the Cue Point into.
4) Press
[MARK].
b. ON THE SHOTBOX
1)
Recall the Cue Point that has been LEARNED as a PTL.
2)
Select the Bank in which the clip is to be stored and press [LEARN].
3)
Press the desired ShotKey. (The name of the clip will be displayed on the
Shotbox with a ‘#’ sign before its name, indicating that the clip was saved as a
PTL.)