DNF Controls 2034CL-TO-PBIO - Manual (Page 10)

10 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
6. PLAY MODES
There are now three PLAY modes available:
NORMAL PLAY
[LOOP ENABLE] = off [PTL] = off
LOOP PLAY [LOOP ENABLE] = on [PTL] = off
PLAY-TO-LOOP [LOOP ENABLE] = on [PTL] = on
NOTE: All transport modes, other than PLAY, are disabled when [LOOP ENABLE] is ON.
a. NORMAL PLAY
‰ This mode is active when [LOOP ENABLE] and [PTL] are not selected.
‰ The clip will play from its present location to the OUT point and stop.
‰ If the clip is beyond the OUT point, it will play to the END of the clip.
b. LOOP PLAY
‰ This mode is active when [LOOP ENABLE] is selected and [PTL] is not selected.
‰ The clip will play in an infinite loop between the IN and OUT points.
‰ If the clip is beyond the OUT point, it will CUE to the IN point and then start
playing.
c. PLAY-TO-LOOP
‰ This mode is active when [PTL] is selected. ([LOOP ENABLE] is automatically
enabled.)
‰ The clip will play from where it is parked (usually at the start) to the OUT point,
then CUE to the IN point and play in an infinite loop between the IN and OUT
points.
‰ If the clip is beyond the OUT point of the LOOP when [PLAY] is pressed, it will
first CUE to the START of the clip and then go into PLAY-TO-LOOP.
NOTE: If no IN point is marked, the default IN point is the START of the clip, and if no
OUT is marked, the default OUT is the END of the clip.