DNF Controls 2034CL-TO-PBIO - Manual (Page 21)

21 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
ST300 SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
DISPLAY
SOFTWARE
VERSION
The version number for the currently installed software is displayed.
PBIO ADDRESS
Press VTR key to assign PBIO address.
Display shows:
Enter address using numeric keypad. Repeat for all VTRs assigned.
SWITCHER TYPE
Select your switcher type. GVG = Grass Valley Group (default) or Sony.
For Phillips DD35 with PBus, use GVG.
RECALL
Press Normal or Redirect (Redir).
MODE When one and only one clip is learned into a Cue Point, the Clip will be
REDIRECTED to load on the currently selected VTR if REDIR is On.
If REDIR is off, the Clip will be loaded on the VTR it is LEARNED into.
PARITY ODD, EVEN or NONE. Match parity sent via the P-Bus to the ST300.
RECORD Press Softkey to select single button or 2-button record.
RECORD = [REC] Only OR [REC] + [PLAY].
PREROLL
Enter Preroll value.
TRANSMIT
CUELIST
Transmits Cuelist to another ST300 or to a PC.
RECEIVE CUELIST
Receives Cuelist from another ST300 or a PC.
PBIO Address = 00
Enter 00-23
ST300 SETUP
Clear Cues SetDefault