DNF Controls 2034CL-TO-PBIO - Manual (Page 12)

12 2034CL-TO, 300 Clip Instant Access System Pinnacle Thunder Protocol,
PBIO Option
9. THE RECUE FUNCTION
If the IN or OUT time is being displayed, the clip will RECUE to the displayed IN or OUT time.
If the IN or OUT time is not displayed, the clip will RECUE to the start of the clip.
NOTES:
‰ All transport modes, other than PLAY, are disabled when [LOOP ENABLE] is ON.
‰ When no IN point is set, the current clip location will be used as the IN point.
‰ There MUST be at least 4 seconds between IN and OUT points for any LOOP.
10. LOAD
a.
Select a VTR by pressing VTR [1], VTR [2], VTR [3] or VTR [4].
b.
Load the desired clip using the CLIP LIST function.
c.
Repeat steps a-b until clips are loaded into the desired VTRs and set the GANG mode, if
required. (Refer to the Function Table for Details.)
11. LEARN ON THE SHOTBOX
a. Press
[LEARN]. The LEARN indicator will turn on.
b.
Select the desired BANK and ShotKey.
c.
The Learned CLIP ID will be displayed on the pressed key.
The ST300 will remember the loaded clip(s), current time and gang configuration of the
active VTR(s).
NOTE: This will overwrite what has been assigned to the key previously.
d. Press
[LEARN] to exit at any time.
NOTE: The [LEARN] key toggles LEARN mode on/off.