Diamondback 1190 Er User Manual

Page 7

1190 Series Owner’s Manual

Assembly Instructions (continued)

comfort position and tighten the nut at the same time.

Step 6: Pedals
1. Using a 15mm open-end wrench to firmly affix the pedals to the cranks. The

pedals should be tightened as much as possible to prevent the pedals from
becoming loose. The pedals should also be checked after 8 hours of use to
ensure they are affixed properly as they can loosen after use.

2. The left and right pedals are different and are denoted as right or left on the

bottom of each pedal. NOTE: Left pedal threads counter-clockwise.

Step 7: Water Bottle
1. Place the bottle holder on the console mast. Insert and tighten the two

M5x12mm screws using a Phillips screwdriver.

2. Snap the water bottle into the holder.

Step 8: Leveling Pad
1. Adjust both leveling pads, located on the bottom of the stabilizer bar, to

ensure your equipment is leveled with floor.

1190seriesOM 5/21/08 2:31 PM Page 8

This manual is related to the following products:

1190 Sr