2 start-up sequence xe "start-up sequence, 3 post installation checklist, Start-up sequence – Daktronics GPR-12EV-RGB User Manual
Page 26: Post installation checklist, 2 start-up sequence
20
Start-up Procedure
5.2 Start-up Sequence
Each time the display is turned on, an initialization sequence runs.
Attribute and Description
Example
Current Firmware Version Running on Display
M4-GalaxyProRev 4.X.X
Current Root File System Version Running on Display
Rfs X.X.X
Display Size
Row x Column
Display Color Type
Bit Depth of Display
RGB
32
Currently Configured Time Zone
America/North Dakota/Center
Current IP Address of Display
Varies
Name of Web Service and Port It Currently Runs On
Srvc: DisplayConfig
Port: 4500
Name of Web Service and Port It Currently Runs On
Srvc: DisplayStatus
Port: 4501
Name of Web Service and Port It Currently Runs On
Srvc: PlayControl
Port: 4502
Name of Web Service and Port It Currently Runs On
Srvc: SecurityManagement
Port: 4503
Name of Web Service and Port It Currently Runs On
Srvc: FileTransfer
Port: 4504
Name of Connected Sensor and Its Offset (Address)
Sensor: TEMP
Offset: Addr: 1
Name of Connected Sensor and Its Offset (Address)
Sensor: LIGHT_LUX
Offset: Addr: 2
User-Defined Display Description
East Employee Entrance
The order of services and sensors is subject to change. After the initialization sequence is
complete, the display will blank. A single pixel will flash in the lower right corner of the
display to show that the display has power, but no presentations are currently running.
5.3 Post Installation Checklist
Verify the following after starting the display:
•
Assure all ventilation fans are fully operational.
•
Inspect all intake and exhaust vents for obstruction.
•
Confirm proper communications from the control computer to the display(s).
•
Assure proper communications between display faces when applicable.