Daktronics GPR-12EV-RGB - Manual (Page 12)

6 Mechanical Installation
2.2 Support Structure Requirements
The installer must ensure the support structure and hardware can support the display, and
that the structure follows all local and national structural codes. Support structure design
depends on the mounting method, display size, and weight.
Because every installation site is unique, no single procedure is approved by Daktronics for
mounting GalaxyPro displays. This section contains general information that may or may not
be appropriate for this particular installation. Refer to Figure 2 and Figure 3 for basic display
setups.
Also remember the location of mounting clips and the clearance needed for the power/signal
terminations and ventilation systems on the back of the display, as shown in Figure 6.
Display height and wind loading are also critical factors to consider. This information can be
found on the Shop Drawing which was supplied with the order.
Figure 6: Section Rear View