Daktronics GPR-12EV-RGB - Manual (Page 15)

Mechanical Installation 9
Combining Sections
1. Install the alignment pins in the top edge of the bottom section by screwing them
into the holes where the eyebolts were located. Refer to Figure 12 for an example.
2. Attach the bottom section to the support structure by welding or using 1 /
2
" grade-5
(or stronger) bolts and hardware. Secure all clip angles.
3. Set the top section on top of the bottom section with the aid of the alignment pins.
Refer to Figure 12 for an example.
4. Remove the alignment pins and attach the sections together with 1 /
2
" grade-5 (or
stronger) bolts and flat and lock washers. Refer to Figure 11 for an example.
5. If additional sections will be added for width, attach the sections left to right with
1 /
2
" grade-5 (or stronger) bolts and flat and lock washers. Refer to Figure 11 for an
example.
2.5 Optional Temperature Sensor Mounting
If an optional temperature sensor is used with this display, refer to Appendix B for mounting
and signal connections.
Figure 11: Section Connections
Figure 12: Combining Sections