Daktronics GPR-12EV-RGB - Manual (Page 21)

Power Installation 15
3.7 Power Connections Between Sections
If additional sections are added for width, power must be routed from the first (left) section
to any subsequent sections. Refer to Figure 17 for examples.
1. Attach the PVC coupler provided with the subsequent
section(s) to the lower opening between sections. Refer to
Figure 16 for an example.
2. Power interconnect wires are pre-terminated at the main
section’s power termination panel.
3. Route the power interconnect wires from the main (left)
section through the lower PVC coupler into the subsequent
section(s).
4. Connect the power interconnect wire to the power termination panel as described in
Section 3.5.
Figure 16: PVC Coupler
Figure 17: Section Power Connections