Daktronics AF-3010-34 - Manual (Page 31)

Modem
Terminate the signal telephone wires to the 10 position terminal block labeled “IN
MODEM” (TB42) as follows:
Figure 20: Modem Signal Connections
Telephone Wires Terminal Block
N.C. Pin 1
N.C. Pin 2
TIP-P Pin 3
Ring-P Pin 4
N.C. Pin 5
N.C. Pin 6
Drawing A-88426 shows an example modem system setup.
Fiber Optic
Route conduit and fiber cable from the PC to the left end of the master display.
Continue routing fiber to the controller box. Refer to Drawing A-110559 for an
example fiber system layout.
Connect fiber to J2 and J3 at the signal converter end (0A-1127-0239)
·
· Connect fiber to J4 and J5 at the display end
Electrical Installation 3-9