Daktronics AF-3010-34 - Manual (Page 21)

2.6 Display Cabinet Mounting
Reference Drawings:
Mounting Drawing, AF-3010-*****-9-*........................... Drawing A-102469
Shop Drawing................................................................ Refer Appendix C
It is the customer’s responsibility to ensure that the installation will meet local
standards. The mounting hardware must be capable of supporting all components to
be mounted. The mounting hardware and method are the responsibility of the
customer. Refer to shop drawings located within Appendix C for the approximate
weight and size of each model of display. Daktronics is not responsible for the
installations or the structural integrity of support structures done by others.
Daktronics has recommendations for both a wall mount method and a pole mount
method. Remember to have all mounted displays inspected by a qualified structural
engineer.
Note: The display has hinged face panel. Care must be taken to allow the door to
properly open (refer to Drawing A-102469).
Wall Mount
Note: Because each site differs, the Daktronics wall mount kit is not a complete
installation kit. It is the customer’s responsibility to determine the proper wall
mounting method and location.
Refer to Drawing A-102469 for a suggested wall mount method. The wall mounting
channels are attached to the rear of the display by Daktronics. Notice that the vertical
distance between the mounting channels is 21". The number of attachment points
needed and the wall structure must be reviewed by a qualified structural engineer and
meet all national and local codes.
Pole Mount
Refer to Drawing A-102469 for a suggested pole mount method. The location of the
poles needs to be determined by the customer. The number of poles needed and the
pole structure and footings must be reviewed by a qualified structural engineer and
meet all national and local codes.
One (1) Daktronics provided mounting kit includes:
· Clamping Channel (qty. 2, attached to rear of display by Daktronics)
· Clamping Angles (qty. 4)
· 1/2" Threaded Rod (qty. 8)
· 1/2" Nut (qty. 16)
· 1/2" Lock Washer (qty. 16)
Mechanical Installation 2-3