Daktronics DF-1060 - Manual (Page 8)

1-2 Introduction
All references to drawing numbers, appendices, figures, or other manuals are
presented in bold typeface, as in this example: “Refer to the Component Placement
Diagram, Drawing A-69945, in Appendix A for the power supply location.”
In addition, any drawings referenced within a particular section are listed at the
beginning of that section. Drawings may be referenced by title or by title and
drawing number as in the following example:
Reference Drawing:
Component Placement Diagram, A-69945 ...................... Appendix A
Daktronics identifies manuals by the engineering document (ED) number located on
the cover page of each manual. For example, this manual would be referred to as
ED-14305.
Daktronics displays are built for long life and require little maintenance. However,
from time to time, certain display components will need to be replaced. The
Replacement Parts List in Section 3.8 provides the names and part numbers of
components that may need to be ordered during the life of this display. Most display
components have a white label that lists the part number. The component part
number is in the following format: 0P-XXXX-XXXX (circuit board) or 0A-XXXX-
XXXX (multi-component assembly).
Following the Replacement Parts List is the Exchange/Replacement Procedure in
Section 3.9. Refer to these instructions if any display component needs repair or
replacement.
Please list the model number, display serial number and the date this display became
operational in the spaces provided on the second page of this manual. When calling
Daktronics customer service, have this information available to ensure that your
request is serviced as quickly as possible.
1.2 Manual Overview
This manual details large-size outdoor digit sets. It is divided into the following
sections:
Section I Introduction covers the basic information needed to make the
most of the rest of this manual. Take time to read the entire
introduction, because it defines terms and explains concepts
used throughout the manual. This section contains an
overview of the product, display specifications, product safety
information, and labeling and numbering descriptions.
Section II
Mechanical and Electrical Installation provides general
guidance on display mounting and terminating power and
signal cable at the display.