Daktronics DF-1060 - Manual (Page 40)

5-2 Lottery Display Operation
Lottery Display Startup
To operate the DataMaster Lottery displays, the DataMaster 100 must first be
programmed to the Lottery display function. Use the <
SET FUNCTION > key on
startup. Use the following table as a guide to startup procedures.
LCD Screen Action
CURRENT FUNCTION
LOTTERY
Plug the wall pack transformer into a 120 V AC
power outlet, and connect it to the DataMaster
100.
This display appears briefly, showing the
current function of operation.
CHANGE FUNCTION?
PRESS SET FUNCT
This message appears next on the screen.
If “LOTTERY” was shown on the bottom line of
the LCD during startup, do nothing. The
controller will automatically default to the
previous display settings.
If a function other than “LOTTERY” was shown
on the bottom line of the LCD during startup,
press the < SET FUNCTION > key while the
second LCD prompt is displayed.
SELECT FUNCTION
LOTTERY
↓↑
Press the arrow up or down keys < ↑↓ > until the
Lottery option is shown. Press the < ENTER >
key to accept.
The handheld controller should now be ready for use. The controller will
“remember” the last function setting, so this step should only need to be done with a
new controller, or one that is configured for different displays. Press any of the keys
listed below to operate the controller.
Lottery Display Controller Operation
The DataMaster 100, configured to the Lottery display option, defaults to showing
the current display settings on power-up. The following text will be shown on the
LCD.