Daktronics Rear-Ventilated GalaxyPro GP3 Series - Manual (Page 9)

4 Installation Preparation
Main Disconnect
Daktronics requires installation of a power disconnect switch with the display so all ungrounded
conductors can be disconnected near the point of power connection.
2.4 Required Tools
The following table lists the minimum tools Daktronics recommends having on site for each
installation. Daktronics only provides the specialized tools needed to complete the installation.
Daktronics Provided Customer Provided
Splice Wrench Hex Head Wrenches – 1 /
8
” and 3 /
16
”
Flathead and Phillips Head Screw Drivers
Crane or Lift Truck
Step Ladders
Computer with Venus
® 1500 Software and Internet Explorer ® Installed
Ratchet and/or Impact Wrench – 11 /
16
”
Socket Set – Sizes up to 1 1 /
16
” Needed
Tape Measure
Utility Knife