Daktronics Rear-Ventilated GalaxyPro GP3 Series - Manual (Page 6)

1
Section 1: Introduction
This manual provides the necessary information to install and service a GalaxyPro ® GP3 series display.
Please read and understand all steps in this manual before beginning the installation process.
For a smooth installation, complete the steps in this manual in order. Contact Daktronics Technical
Support with any questions before or during the installation process.
1.1 Limitation of Liability
The factory warranty will be nullified if:
• The display is not installed according to the steps in this manual
• Proper electrical service is not provided or the display is not grounded properly
• Unauthorized modifications are made to the display, display cabinet, or the control
system
Refer to Appendix B at the end of this manual for the full Daktronics Warranty and Limitation of
Liability.
1.2 Contact Information
For assistance before, during, or after display installation, please contact Daktronics Technical
Support: 800-DAKTRONICS (800-325-8766).
1.3 Model Number Guide
GalaxyPro ® GP3 model numbers are defined as follows:
GP3-RxC-M-RGB-F
GP3
= Outdoor GalaxyPro ® display
R = Number of pixel rows high
C = Number of pixel columns long
M = Pixel pitch in millimeters
RGB = LED Color: R (Red), G (Green), B (blue)
F = Face setup: SF – Single Face or 2V – Primary/Mirror
Figure 1 shows a label on the display’s
back where the model number and
power requirements are located.
Displays are either single face (SF) or
two view (2V). In 2V units, the first
display is referred to as the primary
and the second is called the mirror. If the second display is mounted more than 15 feet (4.5 m)
from the primary display, two primary displays are used.
Figure 1: Display Label
Introduction