Daktronics Rear-Ventilated GalaxyPro GP3 Series - Manual (Page 21)

16
Network and Communication Installation
8.4 Connecting To A DHCP Network And Using A Static IP Address
The following steps explain how to configure a display when it is connected to a network that
supports DHCP, but a static IP address is desired for the display.
Network Requirements
• Existing Network
• Available network port, configured properly
• PC with Venus 1500 software installed
• Static IP information (provided by customer)
Configuration Steps
1. Connect a computer to the display setup for Obtain IP address automatically.
2. Turn display on.
3. Launch DisplayFind and discover the display.
4. Once the display is found, click the link to launch the configuration utility.
5. Click Logon to connect to the display (refer to the help file for additional information about
the configuration utility).
6. Configure the IP settings.
7. Click Upload Configuration.
8. Log out of the configuration utility.
9. Turn display off.
10. Disconnect the computer from the display and connect display to the network.
11. Make sure computer with Venus 1500 software installed is turned on.
12. Ensure computer has an established link with the network.
13. Turn display on.
14. Configure the display in Venus 1500.
8.5 Connecting To A Network And Using A Static IP Address
The following steps explain how to configure a display when it is connected to a network that
does not support DHCP.