Daktronics Rear-Ventilated GalaxyPro GP3 Series - Manual (Page 11)

6 Display Installation
Note: Ensure the angle between the top of the display and the lifting strap is greater than 55
degrees, as shown in Figure 2.
4. Apply tension to the lift lines.
5. Attach tag lines to the bracket shown in
Figure 3.
6. Unbolt the display from the shipping braces.
7. Lift the display off the truck to the display structure.
Note: Do not lift displays in wind speeds greater than 20 mph.
8. Mount the display to the structure by welding or bolting all
T-Clips to horizontal stringers.
Note: Use all T-Clips when mounting the display.
Note: The T-Clips are installed in the recommended locations
at Daktronics, but can be moved 12 inches either way to avoid
obstructions. Refer to the label on the display for limitations.
9. Remove crane support and tag lines from the display once
mounting is complete.
10. Locate the top border caps and install over lift eyes using
provided Tek screws.
Figure 3: Tag Line Bracket