Daktronics Rear-Ventilated GalaxyPro GP3 Series - Manual (Page 12)

7 Section Splicing
Section 4: Section Splicing
4.1 Display Section Numbering
For multiple-section displays, each section is numbered for
easy identification. In a two-section display, shown in Figure
4, the top section is 101 and the bottom section is 201.
In four-section displays, shown in Figure 5, the upper-left
display section is 101 and the section to the right is 102; the
second row of sections is 201 on the left and 202 on the right.
Note: Left and Right sections are pre-assembled prior to
shipping for displays up to 48 feet wide.
4.2 Section Splicing Instructions
1. Ensure the splice key is
inserted in the channel of the
bottom section, as shown in
Figure 6.
2. Attach a crane or lift truck
to the lift eyes of the top
section and apply tension.
3. Unbolt the top section of the
display from the truck bed
and unbolt A-frame.
4. Lift the display top section off the truck high
enough to spin around 180 degrees.
Section 201
Section 101
Figure 4: Two-Section Display Section
Numbers
Section 201
Section 101
Section 202
Section 102
Figure 5: Four-Section Display Section Numbers
Top
Section
Bottom
Section
Splice
Key
Figure 6: Splice Key In Channel