Contemporary Control Systems BAScontrol20 User Manual User Manual
Page 50
TD100700-0MB
50
First, notice the location specified as the New Backup/Recovery File. Is this the file
you want restored? Second, look at the top of the screen and you will see the
following parameters:
IP Address
Netmask
Gateway
BACnet Device Instance
BACnet Device Name
These five parameters will be loaded into the controller being restored. Are these
five parameters that come from the saved zip file what you want? Is the IP address
of the target address the same as shown on this page? If so, click on Restore for a
simple restore process.
Once the Restore operation is completed, the application program in the target
controller continues to run the old program. To run the newly restored program, a
controller Restart is required. You will be prompted for an immediate restart. You
can do it now or later.
To restart the controller later, click the Restart BAScontrol button on the BASbackup
main page
or restart from the controller’s web page. Regardless of what method is
used, care should be exercised when restarting the program on an active controller.
The controller and application should be in sight of the systems integrator initiating
the restart to confirm a safely functioning restart of the application.