Contemporary Control Systems BAScontrol20 User Manual - Manual (Page 27)

TD100700-0MB
27
5.1.4.1 IP Configuration
As shown on the left side of Figure 14 , the following parameters can be adjusted,
followed by a Submit:

IP Mode Choose either Static IP (the default) or DHCP.

IP Address Changing the default value of 192.168.92.68 is recommended.

Netmask The default value of 255.255.255.0 is adequate for most users.

Gateway If your Ethernet LAN has a gateway (router) enter its IP address here.
After the BASC20 has been given its initial configuration, it will be ready for use in
the full original Ethernet network. The temporary network constructed in
Figure 11
should be dismantled and the PC re-configured to restore its original IP address.
5.1.4.2 BACnet Configuration
As shown on the right side of Figure 14 , the following parameters can be adjusted,
followed by a Submit:

Device Object Name You must change the default name (BAScontrol System) to
be unique throughout the entire BACnet internetwork.

Device Instance This 22-bit value (0 –4,194,303) must be unique throughout the
entire BACnet internetwork. It defaults to 2749.

UDP Port The default of 47808 should usually not be changed.

BBMD IP Address Enter the address of the BBMD with which the BASC20 will
perform Foreign Device Registration (FDR)
— if the BBMD is
not in the same subnet as the BASC20.

BBMD Reg Time Specify the seconds between successive FDR registrations.
5.1.4.3 Enable Protocol
On the right side of Figure 14 , three functions can be adjusted, followed by a
Submit:

BACnet Disabling BACnet (on by default) will free more memory for Sedona.

Sedona Disabling Sedona (on by default) will free more memory for BACnet.

FTP If needed, enable FTP (which by default is unchecked). If you select
FTP, BACnet and Sedona are automatically de-selected.
5.1.4.4 Authentication
On the right side of Figure 14 , you can use up to 63 characters to specify User
Name and Password, followed by Submit:

User Name You can change the default admin to any User Name you wish.

Password You can change the default admin to any Password you wish.
5.1.4.5 Kit Update
Consult the BASC20 support page for detailed instructions on using this feature:
www.ccontrols.com/support/bascontrol20.htm