Contemporary Control Systems BAScontrol20 User Manual - Manual (Page 49)

TD100700-0MB
49
Figure 35
— The Authentication Screen
If you are successful, no error messages will appear. Once the Working… message
ceases on the main page, you can look at the content of your backup zip file by
double-clicking it. You should see the four files that were identified earlier
— as
shown in Figure 36 .
Figure 36 — Content of the RTU_1 Backup ZIP File
6.5.4 Restoring a Sedona Project
Restoring a Sedona Project is just as easy. Before you begin the restore process, set
the IP address on the main page to the location of the controller to be restored. The
controller must be powered up and accessible. Then click on the Restore button on
the main page to get you to the Restore Setup screen as shown in
Figure 37 . Notice
that the field values are dimmed. This indicates that these values are read-only. They
will remain read-only until the Change recovery data checkbox is checked.
Figure 37
— Restore Setup Screen (Read-Only Mode)