Comtech EF Data DT-4500 Series - Manual (Page 111)

DT4500 Series Down Converters MN/DT4500.IOM
Index Revision 1
93
N
New in the Manual, 16
Non-Redundant Converter Configuration, 24
Non-Redundant Converter Configuration with Rx
SW Module (RSM-xx) Installed, 24
O
Offset Adjustment, 54
Operating Functions – Front Panel, 26
Operation, 27
Overview, 1, 25, 41
P
Packed Alarm Status, 75
Packed Configuration Status, 73
Packed Maintenance Status, 74
Packed Utility Status, 74
Physical Addresses, 60, 63
Physical Configuration, 15
Power Faults, 37
Pre-Select Function Menu, 36
Prime Power, 87
Prime Power Connection, 19
Prime Power Switch, 16
Program Pre-Select, 37
Program Preset, 69
Protocol, 58
R
Rack Mount Installation, 19
Rear Panel, 2, 25
Rear Panel Connections, 20
Redundancy Mode, 36, 69
Redundancy Systems – Converter Removal, 54
Redundant Configurations, 43
Redundant Configuration – Dual Source IF
Input,
46
Redundant Configuration – Single Source IF
Output w/IOM and RSM-XX Installed, 44
Redundant Configuration Diagram – Single
Source IF Output w/IOM and RSM-XX
Installed, 44
1:1 Redundant Configuration Diagram – Single
Source IF Output w/IOM and TSEQM-
XX Installed, 44
1:1 Redundant Configuration Diagram – Dual
Source IF Output with IOM-XX and
RSM-XX Installed, 46
Redundant System Configuration, 49
Redundant System Operation, 41
Reference Oscillator Module, 88
Reference Oscillator Tuning, 64
Remote Control, 57
Response Ending, 62
Response Timeout, 58
RF Converter Module, 88
RF Signal Conversion, 82
RS-232, 59
RS-485, 59,
RS-485/RS-232 Interface (COM 1),
Connector 1, 21
S
Select a Preset, 69
Spares, 89
Specifications, 4
Start Character, 61
Status Commands, 71
Stored Alarm, 75
Stored Faults, 38
Stored Faults Menu Commands, 33
Summary Alarm Status, 73
Summary Fault Output (RELAY),
Connector P1, 22
Switching Power ON, 27
Synthesizer Faults, 38