Comtech EF Data CLC-10 - Manual (Page 67)

CLC-10 Comtech LPOD Controller Handheld Terminal M&C Accessory Revision 3
Serial-Based M&C using the CLC-10 MN-CLC10
3–35
Parameter Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are printable ASCII characters)
Response to
Command
(Target to
Controller)
Query
(Instruction
Code and
Qualifier)
Response to Query
(Target to
Controller)
Set RTC Time TIM= 6 bytes Command or Query.
Sets or returns the real-time clock time, from midnight, in the form hhmmss, where:
hh=hours, from 00 to 23
mm=minutes, from 00 to 59
ss=seconds, from 00 to 59
Example (time=23 hours, 12 minutes and 59 seconds since midnight): <1/TIM=231259’cr’
>0001/TIM=’cr’’lf’
TIM =
TIM?
TIM *
TIM? TIM=xxxxxx
(See Description of
Arguments)
Temperature N/A 5 bytes Query only.
Returns the temperatures of the Heatsink in the form of sxxxx, where:
s=sign (+) or (-)
xxxx=temperature.
Example: <1/TMP=+26.0
TMP= TMP? TMP=sxxxx
(See Description of
Arguments)
Retrieve Number
of Unread Stored
Alarms E
N/A 2 bytes Query only.
Returns the number of stored alarms that remain unread in the alarm log, in the form xx. A maximum of 255
events may be stored in the alarm log. Numbers over 99 are reported as 99.
Example reply: <1/TNA? ’cr’
>0001/TNA=14’cr’’lf’
TNA= TNA? TNA=xx
(See Description of
Arguments)
Retrieve Number
of Unread Stored
Events
N/A 2 bytes,
numerical
Query Only.
Returns the number of stored events that remain unread in the events logs, in the form xx.
Example: <1/TNE? ’cr’
>0001/TNE=18’cr’’lf’
TNE= TNE? TNE=xx
(See Description of
Arguments)
Time Protocol
Enable
TPE= 1 byte,
numerical
Command or Query.
Sets or returns the Time Protocol setting in the form x, where:
0=Time protocol disabled
1=Time protocol enabled
Example (Time protocol enabled): <1/TPE=1’cr’
TPE=
TPE?
TPE? TPE=x
(See Description of
Arguments)
Time Protocol
Server
TPS= 15 bytes,
alpha-numeric
Command or Query.
Sets or returns the Time Server IP address for the Unit Tx Ethernet management port, in the form
xxx.xxx.xxx.xxx
Default value: 255.255.255.255
Example: <1/TPS=192.168.001.005
TPS=
TPS?
TPS? TPS=
xxx.xxx.xxx.xxx.yy
(See Description of
Arguments)