Comtech EF Data CLC-10 - Manual (Page 23)

CLC-10 Comtech LPOD Controller Handheld Terminal M&C Accessory Revision 3
Setup MN-CLC10
2–3
2.2 Connecting the CLC-10 to the SSPA Using the CA-0020526 Serial
Interface Cable
The Figure 2-4 diagram shows the connections for the CA-0020526 Serial Interface Cable. The
cable’s RJ-11 end connects to the CLC-10 TechTerm Handheld Terminal. The 19-pin circular
connector end connects to either the SSPA’s ‘J6 | COM1’ port in standalone applications, or the
1:1 Redundant Loop Cable Assembly’s ‘J1’ receptacle in 1:1 redundancy applications.
Figure 2-4. CA-0020526 Cable Connections Diagram
2.2.1 CA-0020526 RJ-11 Connector
Figure 2-5. CA-0020526 RJ-11 Connector to CLC-10 Connection
Typical for standalone or 1:1 redundancy configurations – Follow these steps to connect the
CA-0020526 Serial Interface Cable to the CLC-10:
Step Task
1 Press down the tab on the CA-0020526 cable RJ-11 plug, and then insert the plug into the CLC-10’s
R-11 jack.
2 The connection is complete when the tab ‘clicks’ into position inside the jack (Figure 2-5).