Comtech EF Data CLC-10 - Manual (Page 31)

CLC-10 Comtech LPOD Controller Handheld Terminal M&C Accessory Revision 3
Setup MN-CLC10
2–11
2.6.2 CLC-10 Display
The CLC-10 features a LED backlit supertwist nematic
display that affords you an expanded viewing angle,
optimal readability in low-light conditions, and realizable
operation in extreme temperature environments (-4° F to
+158° F / -20° C to +70° C). The display provides four content rows, at 20 characters per row,
using the standard U.S. ASCII character set.
2.6.3 CLC-10 –to– SSPA Communication Settings
• Sect. 3.4.3 Basic Protocol in Chapter 3. SERIAL-BASED M&C USING THE
CLC-10.
• Sect. 4.5.5.3.1 Config | Amplifier in Comtech EF Data’s LPOD Outdoor
Amplifier / Block Up Converter (BUC) Installation and Operation Manual
(CEFD P/N MN-LPOD) or SPOD Outdoor Amplifier Installation and Operation
Manual (CEFD P/N MN-SPODPSX).
• Two Technologies, Inc. TechTerm® Technical Reference Manual (2T
Document 15776, available from www.2t.com).
SSPA Configuration: The CLC-10 ships preconfigured for interoperability with the SSPA. The
character format should be 8N1 (8 data bits, no parity, 1 stop bit). The maximum allowable
serial baud rate for the CLC-10 is 9600 bps. In order for the SSPA to properly communicate with
the CLC-10, its serial baud rate must be preset to 9600 baud using the SBR command via the
remote serial interface, or in the Serial section on the SSPA Web Server Interface Config |
Amplifier page.
CLC-10 Configuration: Should there be any reason to reconfigure the CLC-10 for proper
communication with the SSPA, follow these steps:
Step Task
1 Hold CTRL and SHIFT and press F1 to access the CLC-10 Parameter menu. Alternately, disconnect the
CA-0020526 Serial Interface Cable from the CLC-10 while simultaneously holding the CTRL, SHIFT, and
F3 keys and then reconnect the cable to the CLC-10.
2 The CLC-10’s Parameter menu appears; its first
configurable parameter appears on the top row of the
display, and action prompts are provided on the next three
rows:
To navigate between parameter settings:
• Press F2 to move to the NEXT parameter
• Press F3 to return to the PREVISION parameter.
Press F1 to CHANGE (edit) the currently selected parameter.