Comtech EF Data CLC-10 - Manual (Page 33)

3–1
Chapter 3. SERIAL-BASED M&C USING
THE
CLC-10
3.1 Important Disclaimer
This guide assumes user familiarity with operation of the LPOD or SPOD – referred collectively as the SSPA through the remainder of this
chapter. The bulk of content in this chapter is taken directly from Chapter 5. SERIAL-BASED REMOTE PRODUCT MANAGEMENT in
Comtech EF Data’s LPOD Outdoor Amplifier / Block Up Converter (BUC) Installation and Operation Manual (CEFD P/N MN-LPOD) and
the SPOD Outdoor Amplifier Installation and Operation Manual (CEFD P/N MN-SPODPSX).
The information provided in this chapter is intended for reference only. You should refer primarily to the latest revision of the pertinent
SSPA manual for the most current Remote Commands and Queries available to the SSPA via serial remote control.
3.2 Introduction
This chapter describes the SSPA’s serial-based monitor and control (M&C) functions, accessible when the SSPA is connected to the
CLC-10 in either Standalone or 1:1 Redundancy operation.
This chapter summarizes key parameters and procedures, and their associated remote commands and queries. Detailed instructions for
use of the serial remote control communication command and query interface are also provided.