Comtech EF Data RC-1160 - Manual (Page 23)

Installation Revision 1
RC-1160 RC-1260 Redundancy Switch Controllers MN-RC1160RC1260
2–1
Chapter 2. INSTALLATION
This chapter provides the following information for the switch controller:
• Unpacking
• Installation
• Power connection
• External connections
2.1 Unpacking
The switch controller is packaged in a preformed, reusable cardboard carton containing foam spacing for
maximum shipping protection.
CAUTION
Do not use any cutting tool that will extend more than 1 inch (2.54 cm) into the
container and cause damage to the unit.
To remove the switch controller:
1) Cut the tape at the top of the carton (indicated by OPEN AT THIS END).
2) Remove the cardboard/foam spacer covering the switch controller and caddypacks.
3) Remove the redundancy switch controller, caddypacks, manual, and power cord from the carton.
4) Save the packing material for reshipment purpose.
5) Inspect the equipment for any possible damage incurred during shipping.
6) Check the equipment against the packing list to ensure that the shipment is complete.