Comtech EF Data OMS11 - Manual (Page 67)

Appendix B OMS11 1:1 Redundancy Switch
B-4 TM133 – Rev. 1.1
If a command packet is sent and not received at its intended destination, a timeout condition can
occur because a response message is not received by the packet originator. On receiving
devices slaved to an M & C computer, the timeout delay parameters may be programmed into the
equipment in accordance with site requirements by Radyne Corp. prior to shipment, or altered by
qualified personnel. The FSN handshake routines must account for timeout delays and be able
to introduce them as well.