Ip a, Mac a – Comtech EF Data CiM-25/600 User Manual
Page 63
CiM-25/600 IP Enabled M&C
Rev. 3
SNMP Interface
CD/CIM25600.IOM
43
3.6.1 R
ESETTING TO
F
ACTORY
D
EFAULTS
1
Enter the following command:
Command:
<0/RST=’cr’
Response:
>0/RST=
3.6.2 C
HANGING
N
ETWORK
IP A
DDRESS
Perform the following steps.
1
Enter the following command:
Command:
<0/IPA=xxx.xxx.xxx.xxx/yy’cr’
Where x is the IP Address and y is the subnet mask.
Response:
>0/IPA=
Example:
<0/IPA=192.168.001.002/16’cr’
16 would be a subnet mask of 255.255.0.0
2
To query the IP address enter: <0/IPA?’cr’
3.6.3 V
ERIFYING
S
OFTWARE
V
ERSION
Perform the following:
1
Enter the following command:
Command:
<0/SWR?’cr’
Response:
>0/SWR= 1.0.1’cr’
3.6.4 C
HANGING
MAC A
DDRESS
Perform the following:
1
Enter the following command:
Command:
<0/MAC=xxxxxxxxx’cr’
Where x is the MAC Address as shown on the label of the CiM-25.
Response:
>0/MAC=
Example: >0/MAC=006B0000000A’cr’
2
To query the MAC Address enter: >0/MAC?’cr’
IMPORTANT
1. The MAC Address is unique to this unit. Change only under factory
direction or if it does not match the label.
2. Changing the MAC Address to anything other than factory default may
result in erratic operation.