Comtech EF Data CiM-25/600 User Manual
Page 60
CiM-25/600 IP Enabled M&C
Rev. 3
SNMP Interface
CD/CIM25600.IOM
40
3.5.1.14 C
HANGE
HTTP P
ORT
Using the !PT command, the Administrator can set the HTTP Port. The command
protocol is as follows:
Format:
!PT
Response:
Command Successful
Where
Query Format:
!PT ?
Response:
!PT
Notes:
1. The default port is set to 80.
2. Changes made via this command do not become active until the user has sent
a !EE command to commit the changes to EEPROM of the CiM-25.
3.5.1.15 C
HANGE
SNMP T
RAP
A
DDRESS
Using the !TP command, the Administrator can set the SNMP Trap Addresses. The
command protocol is as follows:
Format:
!TP
Response:
Command Successful
Note: An IP Address of 0.0.0.0 disables the trap
Query Format:
!TP ?
Response:
!TP
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25.
3.5.1.16 C
HANGE
SNMP T
RAP
C
OMMUNITY
Using the !TC command, the Administrator can set the SNMP Trap Community. The
command protocol is as follows:
Format:
!TC
Response:
Command Successful
where
Query Format:
!TC ?
Response:
!TC
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25.