ChamSys MagicQ User Manual - Manual (Page 365)

MagicQ User Manual 336 / 355
Table 46.9: Removing Values from the Programmer
Clear all values CLEAR
Clear with 3 sec time 3 CLEAR
Clear selected heads Select heads, SHIFT + CLEAR
Clear to 0 vals CTRL + CLEAR
Remove attrib
Remove attrib
Remove position attribs
Remove colour attribs
Remove beam attribs
Remove intensity attribs
Remove all attribs <* + REM>
Table 46.10: Recording Cues
Record Cue on Playback REC S
Record Cue ID 2.5 2.5 REC S
Record Cue to current Playback REC ENTER
Record to Playback 2 REC 2 ENTER
Record to Cue ID 2.5 Playback 2 REC 2 / 2.5 ENTER
Record sel heads only S
Record sel heads only * + REC
Record sel attribs , select attribs, S
Record entire state of programmer ALL + REC
Record Cue Only / + REC
Record Snapshot THRU + REC
Table 46.11: Record Merging / Removing
Record Merge <+ + REC> S
Record Merge current Cue S + REC
Record Merge current Cue REC + UPD
Record Merge selected head only Hold * and + and press REC
Record Merge all Cue Stack S
Record Merge Cue Id 2 to 4 <+ + REC> 2 THRU 4 S
Record Remove ← + REC> S
Record Remove selected head only Hold * and - and press REC
Record Remove all Cue Stack S
Record Remove Cue Id 2 to 4 ← - REC> 2 THRU 4 S
Set Head 2 at 50% into current cue S + <2 @ 50>
Set Head 2 at +10% into current cue S + <2 @ + 10>
Set Head 2 at 50% all cues S + <2 @ 50 THRU>
Set Head 2 at +10% all cues S + <2 @ + 10>
Table 46.12: Editing Cues
Edit in Programmer INC S, make change, UPDATE
Record merge Change vals in Prog, < + REC>
Remove Cue Stack REM S