ChamSys MagicQ User Manual - Manual (Page 265)

MagicQ User Manual 236 / 355
"user.html" name= "user" METHOD=GET>
"submit" value= "1T" name= "cmd" >
"submit" value= "1U" name= "cmd" >
"submit"name="cmd1T"value="1T">PB1 act "submit" name= "cmd1T" value= "1T" >PB1 act
"submit"name="cmd1U"value="1U">PB1 rel "submit" name= "cmd1U" value= "1U" >PB1 rel
30.5 Remote control using Magic Wand simulator
MagicQ supports a Magic Wand simulator which acts like the MagicQ Playback Wand.
To use the Magic Wand simulator start MagicQ with the command line argument “wand”. MagicQ will run just a simulation of
the Magic Wand controlling the first 4 playbacks from the first Wing.
If you wish to restrict the Wand simulation to only connect to a specific IP address then include the required IP address as the
second command line argument of the IP address.
The MagicQ Wand simulator must be run on a separate system to the one running MagicQ.