Serial remote protocol, Serial touch monitor, Remote trigger type – ChamSys MagicQ User Manual User Manual
Page 338: Remote trigger action, 8 serial remote protocol, 9 serial touch monitor, 10remote trigger type, 11remote trigger action
MagicQ User Manual
309 / 355
42.15.8
Serial remote protocol
Determines what protocol is used on the serial port. If set to “none” then any data received is ignored. Data can be transmitted
from the Macro field of Cue steps in the Cue Stack.
The other protocols are:
• ChamSys Rem (rx)
• ChamSys Rem (tx & rx)
• ChamSys Rem (tx)
• Ideal Touch
• A1 Touch
• Elo Touch
The Touch protocols are for the use of external RS232 serial touch screens with the MQ50, MQ100, MQ200 and MQ300
consoles. Refer to the instruction manual of your touch screen for other serial settings.
See
Controlling MagicQ Using Serial Port
and
for more details.
42.15.9
Serial touch monitor
Determines which monitor on the MagicQ system has a touch screen connected to the serial port.
42.15.10
Remote trigger type
This setting specifies how the remote input port on MagicQ consoles, MagicQ PC Wings and MagicQ Maxi Wings works.
It can be set to None, Make, Break, or Make + Break.
42.15.11
Remote trigger action
This setting specifies specific global actions to be taken on a remote trigger input. The options are:
The options are:
• NONE
• CURRENT PLAYBACK GO
• CURRENT PLAYBACK FLASH
• ADD/SWAP
• SWAP
• DBO
• WING1 PB1 GO
• WING1 PB1 FLASH
• WING1 PB12 GO
• WING1 PB12 FLASH
• PB10 GO