ChamSys MagicQ User Manual - Manual (Page 267)

MagicQ User Manual 238 / 355
Commands can be sent back to back – e.g.
1A2A1S2G3,4I
31.1.1 Remote programming commands
Remote programming commands enable simple programming actions to be carried out from a remote terminal. Remote pro-
gramming commands consist of the program command number followed by parameters and completed with an “H”.
The commands are:
<01> , , [] H Select one or more heads
<02> , , [] H Deselect one or more heads
<03> H Deselect all heads
<04> , H Select group
<05> , , [] H Set intensity of selected heads
<06> , , , [] H Set attribute value of
selected heads
<07> , , , [<16bit>] H Increase attribute of
selected heads
<08> , , , [<16bit>] H Decrease attribute of
selected heads
<09> H Clear programmer
<10> , H Include position palette
<11> , H Include colour palette
<12> , H Include beam palette
<13> , H Include cue
<19> H Update
<20>, H Record position palette
<21> , H Record colour palette
<22> , H Record beam palette
<23> , H Record cue
<30> H Next head
<31> H Previous head
<32> H All heads
<40> H Locate
<41> H Lamp on
<42> H Lamp off
<43> H Reset
<71>, H Remote trigger
<80> , H Test Cue
<81> , H Untest Cue
<82> , H Test Cue Stack
<83> , H Untest Cue Stack
<90> , H Save show showXXXX.shw
<91> , H Load show showXXXX.shw
[] indicates an optional parameter
is an integer between 0 and 100
is an integer between 1 and 1024
is an integer between 1 and 5000
<16 bit> is a flag. 0 for change in 8 bit resolution, 1 for change in 16 bit ←
resolution
is an integer time in seconds
is an integer between 1 and 200
and are integers between 1 and 6145