ChamSys MagicQ User Manual - Manual (Page 266)

MagicQ User Manual 237 / 355
Chapter 31
ChamSys Remote Protocol Commands
ChamSys remote protocol consists of simple commands consisting of a list parameter values separated by commas ‘,’ and ending
in a character A to Z (or a to z). Commands can contain spaces, tabs, and carriage returns; they are all ignored.
The remote protocol is split into remote playback commands and remote programming commands.
31.1 Remote Playback Commands
The commands are:
A Activate playback
R Release playback
T Test playback (activate with level 100%)
U Un-test playback (release with level 0%)
G Go on playback
S Stop (go back) on playback
B Fast back on playback (no fade)
F Fast forward on playback (no fade)
, L Set playback fader level
, , J Jump to Cue Id on playback
P Change page
, I Set intensity channel to level
H Remote programming command
The following parameter values are supported
a number between 1 and 10
an integer between 0 and 100.
an integer between 0 and 100
an integer between 1 and 32769 DMX channel number
an integer between 1 and 65536
an integer between 0 and 99. Note that for Cue ID 1.5 use
50
So for example, to set dimmer channel 4 to 50% you would use:
4,50I
To jump to Cue id 2.5 on playback 8 you would use:
8,2,50J