ChamSys MagicQ User Manual User Manual
Page 364
MagicQ User Manual
335 / 355
Table 46.7: Playback
Step through Cue Stack
>
Step back up Cue Stack
pass:[
(also SHIFT + >)]
Go to next step without time
>>
Go back a step without time
<<
Reassert Playback
S + FLASH button
Take manual control of Playback
S + move manual fader
Change chase / FX speed live
S + turn encoder X
Go to Cue ID 2
S 2 ENTER
Release Playback with 3 sec time
S 3 REL
Release all Playbacks
SHIFT + RELEASE
Release all test Playbacks/Cues/Cue Stacks
CTRL + RELEASE
Enter/exit Blind with 3 sec time
3 BLIND
Make Cue Stack default all pages
Change to Page 1, PLAYBACK,
Table 46.8: Loading Values into the Programmer
Default all attribs
Select heads, LOCATE
Default position attribs
Select heads
Default colour attribs
Select heads
Default beam attribs
Select heads
Default intensity attribs
Select heads
Make active all attribs
Select heads, <* + SET>
Make active pos attribs
Select heads,
Make active colour attribs
Select heads,
Make active beam attribs
Select heads,
Make active int attribs
Select heads,
Make hard all attribs
Select heads, <* + MOVE>
Make hard pos attribs
Select heads,
Make hard colour attribs
Select heads,
Make hard beam attribs
Select heads,
Make hard int attribs
Select heads,
Load Cue from Playback
INC
Load Cue ID 2
2 INC
Load Cue at 40%
@ 40 INC
Load Cue at current level
@ INC
Load entire state of Cue Stack
ALL + INCLUDE
Load selected heads from Cue
<* + INC>
Load selected heads pos from Cue
Load selected heads colour from Cue
Load selected heads beam from Cue
Load selected heads int from Cue
Load from DMX
Select heads,
Snapshot output cues
PROG,
Snapshot active values
THRU RECORD