Monorail installation and troubleshooting, rev6, Monorail troubleshooting, rev6_pg2.pdf – Besa Lighting 8 Ft Monorail (Monorail 12V) User Manual
Page 2
Install the Rail
Install the Rail Adapters
and Elements
Turn the System On
Install Monorail Supports
NOTE:
If necessary, cut the Support
(R12-STAN1 or R12-STAN2)
posts to the desired length.
Raise the rail and secure to the Supports
and the Transformer Feed.
A) Secure the Rail Adapters
to rail in the desired
location for Pendant
or Spotlight Elements.
B) For Pendant Elements,
shorten if necessary and
install the Quick Connect Jack.
C) Install the Elements onto the
Rail Adapters by threading on
the Quick Connect jack.
D) Install the
appropriate
lamps into
the Elements.
and
check all connections for excessive heat.
Loose connections must be tightened to
prevent overheating, which can damage
the system and pose a
re hazard.
Do not overtighten.
HINT:
s
n
o
it
c
e
s
l
i
a
r
e
h
t
ll
a
t
s
n
i
o
t
t
s
e
i
s
a
e
s
i
ti
,
s
n
u
r
g
n
o
l
r
o
F
rst, then install the rail connectors.
IMPORTANT!
power and
refer to the Monorail Troubleshooting Guide.
A) Using a plumbline, mark the
Support locations on the ceiling.
B) Install the Supports onto the ceiling.
½ Hr
≈ 24”
1
2
5
7
6
4