Besa Lighting 8 Ft Monorail (Monorail 12V) - Manual

IMPORTANT SAFETY INSTRUCTIONS:
A) Read all instructions.
B) Do not conceal or extend exposed conductors
through a building wall.
C) For use in dry locations, do not install this system in
damp or wet locations (such as bathrooms).
D) For low voltage exposed insulated conductor systems
m e t s y s s i h t f o t r a p y n a l l a t s n i t o n o d , ) c ( 1 . 0 3 y b d e ri u q e r
oor.
E) re and burns, do not install this
s r o t c u d n o c e r a b d e s o p x e e h t e r e h w m e t s y s g n it h g il
can be shorted or contact any conductive materials.
F) re and overheating,
make sure all connections are tight.
G) Do not install any luminaire closer than 6 inches (15.25
cm) from any curtain, or similar combustable materials.
H) electrical power before modifying
the lighting system in any way.
SAVE THESE INSTRUCTIONS
6695 Taylor Rd. Blacklick, OH 43004 www.besalighting.com
Monorail Installation, Rev. 6 2-13
12V MONORAIL SYSTEM
INSTALLATION GUIDE
Getting Started
NOTE:
To install each component, refer to
individual Installation Instructions that
.t n e n o p m o c h c a e h ti w d e d i v o r p e r a
Carefully remove all of the system components
s n o it c u r t s n i n o it a ll a t s n i g n i d n o p s e r r o c e h t d n a
provided with each component.
NOTE:
c
components of your system may vary.
Transformer Installation Lay Out the Rail Sections
For Remote Transformer:
(R12-RM300 or R12-RM600)
A) Determine accessible Remote
Transformer location.
B) Extend wire (not provided) from
the Remote Transformer to the
J-Box for the Remote Feed
Canopy (R12-REMFC).
C) Install the Remote Feed
Canopy to the J-Box.
HINT:
For optimal performance, it is best
to locate the feed near the
center of the rail system.
IMPORTANT!
eld-cutting rail, clean
middle section to eliminate
all metal fragments.
Do NOT use the Rail Connectors
eld-cut side of the rail,
only use with the factory cut side.
For Surface Transformer
(R12-SM300 or R12-SA150
or R12-SA60LED)
A) Determine the Surface
Transformer or LED Canopy
B) Install the Surface
Transformer or LED
RAIL SECTIONS
END CAPS LIVE CONNECTOR
R E M R O F S N A R T S F F O D N A T S
A) oor
and determine the layout design.
B) eld cut and hand bend
the rail to the desired length and shape.
C) Install the Rail Connectors. Note that
R12-ICONN is conductive, and
R12-DCONN is non-conductive.
D) Install the End Caps
(R12-NDCAP) onto
both ends of the
monorail run.
E) Locate Supports in best
positions. 24” spacing
is recommended.
1
3 2
location.
Canopy to the J-Box.
or LED Canopy: