Besa Lighting Tamburo 16v2 (Semi-Flush Mount) - Manual

6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
INSTALLATION GUIDE
Model 1KM Series (Three Light Med. Base Ceiling 120V)
1KM.01, Rev.2 8-10
Caution: Turn off power to electrical box before installing
1. Carefully unpack parts. Loosen Screws (F) to release
the Mounting Plate (A) from Canopy (E).
2. Secure the Mounting Plate (A) to the Electrical
Supply Box with Machine Screws (B) provided.
3. Attach the fixture Ground wire to the supply
ground and secure with Wire Nut Connector (C).
4. Connect the fixture conductors to the supply
conductors with Wire Nut Connectors (D) as shown:
White fixture wire to white supply wire and black
fixture wire to black supply wire. Carefully push
wires and wire nuts back into outlet box.
5. Position the Canopy (E) over the Mounting Plate
and secure by tightening the Screws (F).
6. Install the Extension Rods (G) first, then secure Glass (H)
with the Decorative Fasteners (I).
7. Using the Leveling Screws (J), adjust the Glass (H) until
it appears level.
8. Insert bulb(s) of indicated type and of no greater
wattage than marked on fixture. Do not exceed
wattage.
Note: The following steps are for the 8” tall glass.
For the 12” tall glass, see the instructions below.
9. The Bottom Glass Diffuser (M) is to be secured to the
Threaded Swivel (L). Use the Washer (O) on the inside
of the Diffuser, then secure with the Decorative Cap
Nut (N).
10. Adjust the Bottom Glass Diffuser (M) by using the
Threaded Swivel (L) until it appears level.
A
F
E
B B
C D
G
H
I
J
N
O
M
L
K
FOR LARGER 12” GLASS, follow steps 1-7 above, then perform the following steps:
9. Remove the Threaded Swivel (L) from the bottom of the
Socket Assembly (K), and replace with the Threaded Nipple
Extension (P). Secure the Threaded Swivel (L) to the bottom
of the Threaded Nipple Extension (P).
10. The Bottom Glass Diffuser (M) is to be secured to the
Threaded Swivel (L). Use the Washer (O) on the inside
of the Diffuser, then secure with the Decorative Cap
Nut (N).
11. Adjust the Bottom Glass Diffuser (M) by using the
Threaded Swivel (L) until it appears level.
P
K
L
*-Decorative Fasteners (I)
provided may vary in
appearance, than as
shown