Besa Lighting 3061 Series (Costaluz) - Manual

POST FITTER INSTALLATION GUIDE
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
Model A001X (120V)
A001X, Rev.2 6-09
CAUTION: Read instructions carefully before installing Fitter.
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
A
C
D
B
GLASS
1. Disconnect power to outlet box at main electric box.
2. Hold the fixture canopy above the post and connect the fixture
wires (A) to the supply wires (black to black and white to white).
Also connect the bare copper ground wire to the supply ground
wire (B). Tighten securely with wire nuts.
Carefully push wire and wire nuts back into the post.
3. Place the fixture canopy over the post and slide down on post
until seated fully. Using an allen wrench, screw the three
provided allen screws (C) into the canopy and tighten securely.
4. Partially install the 3 retaining screws (D) into the canopy.
5. With the power still off, insert bulb of not more
than the recommended wattage.
6. Place the glass onto the canopy. Hook the neck of glass fully
onto the canopy. Tighten the three retaining screws (D).
Do not overtighten the retaining screws.
7. Restore power.