Besa Lighting Andi (Spotlights 12V) - Manual

INSTALLATION GUIDE
Spotlight Elements using Model QF4 Series Hardware
(For use with Besa low voltage lighting systems only)
QF4, Rev.4 9-10
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
IMPORTANT: READ ALL INSTRUCTIONS BEFORE INSTALLING.
DISCONNECT POWER BEFORE INSTALLING OR RE-LAMPING.
INSTALLING THE QUICK CONNECT:
1. Insert the post of the quick connect into the
quick connect adapter.
2. Thread the top half of the conical section until it
seats with the adapter.
3. Adjust fixture position; use caution not to loosen
the conical section.
Quick Connect
Adapter
Top Conical
Section
Low voltage systems operate at higher amperage,
which requires secure connections. A loose or bad
connection can lead to overheating, so it is advised
to check the connections after the first 1/2 hour of
operation. If the connection is hot to the touch,
remove the spotlight then reinstall securely.
ADJUSTMENT OF THE SPOTLIGHT ANGLE:
1. Using the Allen wrench provided, loosen the side
set screws until the spotlight can move freely.
2. Orient the spotlight to the desired angle,
and then retighten the side set screws.
INSTALLING LAMP & SHADE:
QF4
Shade
Check Ring
Threaded Socket
Assembly
MR16
Lamp
Socket
Assembly
Handle
Quick
Connect
Stem
1. Remove the check ring from the threaded portion of the
socket assembly. Attach the shade by sliding the smaller
opening of the glass shade over the threaded portion of
the socket assembly. Secure using the check ring.
2. Place the provided lamp inside the shade so that the two pins
protrude through the back of the shade. Insert the provided lamp
into the socket assembly by aligning the pins with the socket holes,
and gently pushing until the lamp seats.
The lamp provided is one of the following lamp types and
based on the glass shade size:
12-volt MR16 Shielded (glass covered lamp) 50W MAX
for larger glass shades
12-volt MR11 Shielded (glass covered lamp) 35W MAX
for smaller glass shades.
NOTE:
May be used with a Xenon Bi-Pin lamp.
NOTE: Fixture shown is for instructional
purposes, stem length may vary.