beautypg.com

Besa Lighting Bolla (120V Pendants) User Manual

Fixture installation guide

background image

FIXTURE INSTALLATION GUIDE

Model T31T (1 Light Flat Canopy 120V)

T31T, Rev.6 3-09

CAUTION: Turn off power to electrical box before installing

IMPORTANT: before proceeding, retrieve the Glass Shade Installation Guide, which is included with the pendant cord set.

6695 Taylor Rd. Blacklick, OH 43004

www.besalighting.com

1. Carefully unpack parts. Remove the Canopy (A) from the Mounting

Plate by unscrewing the Retainer (B). Fully remove the Retainer from

the threaded nipple, then pull the canopy from the Mounting Plate.

2. If the cord length requires adjustment, simply unscrew the Set Screw

on the Strain Relief (C). Now push the cord up through the Strain Relief

until reaching the desired length. Tighten the Set Screw onto cord until

the cord is firmly held in place. To shorten the cord, cut to the desired

length then strip back the outer jacket and the inner conductors. When

shortening the cord, it is recommended that the polarity is confirmed,

per the Polarity Instructions below.

3. Install the provided Mounting Screws (D) into the Outlet Box,

leaving 1/4” of threading as shown.

4. Attach the house ground wire to the cord green stripe conductor

and bare copper lead, then secure with provided wirenut (E).

Connect the conductors from the fixture cord to the house supply

wires, white stripe to white and clear to black, and secure with

wirenuts provided (F).

NOTE:

Colored Sleeving Has Been Added To Conductors For Identification.

5. Align the circular openings of the keyhole slots (G) of the

Mounting Plate (H) with the Mounting Screws. Push the

Mounting Plate up over the Outlet Box until tight to ceiling,

then rotate the Mounting Plate Counter-clockwise and

secure with Mounting Screws.

A

B

C

IMPORTANT:

Refer to the

Glass Shade Installation Guide to determine

the glass support parts that must be installed over the

Pendant Cord Set, prior to Step 2.

If using the optional 18” Decorative Cord Sleeve(s) (sold separately),

cut the sleeve(s) to the desired pendant length. Replace the Retainer

(B) with the retainer provided with the 18” Decorative Cord Sleeve.

Leave approx. 6” of cord slack to allow installation of glass shade.

CAUTION: Overtightening the set screw could pierce cord and

prevent pendant from operating.

*IMPORTANT:

When Mounting To Smaller Boxes,

It May Be Necessary To Secure

Using These Mounting Holes.

D

F

E

G

Green

Stripe

White

Stripe

H

Clear