Besa Lighting Tomas (Sconces) - Manual

FIXTURE INSTALLATION GUIDE
All electrical connections and the installation of this fixture must be in agreement with local codes,
ordinances or the NEC (National Electric Code) or CEC (Canadian Electrical Code).
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding.
Models using B0042 Backplate
(Medium Base Lamps, Wall Mount 120V)
B0042, Rev.4 3-09
CAUTION: Turn off power to electrical box before installing
6695 Taylor Rd. Blacklick, OH 43004
www.besalighting.com
NOTE: Backplate is for
instructional purposes. Actual
backplate may vary slightly
NOTE: Glass shown is for
instructional purposes. Actual
glass may vary in shape or size.
A
B
C
D
E
F
G
1. Carefully remove parts from package.
2. Remove the Cap Nut (A) to release the
Backplate from the Mounting Bracket (B).
3. Attach the Mounting Bracket to the Outlet
Box (C) with two Machine Screws (D) provided.
4. Connect the electrical leads from the fixture to
the house supply wires, black to black and white
to white, and secure with wirenuts provided (E).
Connect the House Ground Wire to the Green
Ground Screw on the Mounting Bracket (F).
5. Align the circular opening on the Backplate with
the Threaded Nipple (G) on the Mounting Bracket.
Push the Backplate over the Threaded Nipple
until the Backplate is flush with the wall, then
secure with the Cap Nut and Star Washer.
6. With the power still off, insert bulb of not more than
the labeled wattage. Proceed to install glass diffuser.
9. Hold the Glass Diffuser close to the Backplate as shown, then
positon the Cable over the two Cable Clips (K) and under the
Cable Retainer (L). Allow the glass to hang from the Backplate
and confirm that the glass seats closely to the wall. The glass
can be adjusted slightly by tightening the Cable Retainer with
the Allen Wrench provided.
If the Glass Diffuser does not seat close to the wall, then the cable
must be shortened using Cable Clamp (M). Loosen the two screws
and carefully shorten cable, then retighten the screws.
10. Restore power.
I
H
J
7. Remove Cable Kit from bag, then release Cable
Assembly (H) by removing the Decorative Fastener (I).
8. Secure the Cable Assembly to the Glass as shown above.
IMPORTANT: Do not overtighten the Hex Nut (J),
overtightening could cause damage to glass.
K
L
M